<applepi>
Hi all.. I'm trying to get a custom board up via JTAG.. right now I have no access to the OTG, so my only hope is to either get u-boot in RAM and execute from there, or get the obds in RAM, run, and use that to put u-boot on the flash..
<applepi>
I'm very new to this sort of thing and can't seem to get u-boot to execute, I can write it into the RAM and read it back and it checks out correctly, but I can't figure out how to get it to execute. All I can work out is to set the PC to where I've put it and step/go. Is there anyone that could point me in the right direction?
simmel80 has quit [Read error: Connection reset by peer]
<rz2k>
applepi: please ask at meta-freescale or at imx community
simmel80_ has joined #imx6-dev
silviof1 has joined #imx6-dev
silviof has quit [Ping timeout: 240 seconds]
simmel80___ has joined #imx6-dev
simmel80_ has quit [Ping timeout: 240 seconds]
rz2k has quit [Read error: Connection reset by peer]
diego_r has joined #imx6-dev
silviof1 is now known as silviof
kroon has quit [Quit: Leaving]
kbouhara has quit [Ping timeout: 256 seconds]
kbouhara has joined #imx6-dev
Er0l has quit [Ping timeout: 240 seconds]
Er0l has joined #imx6-dev
applepi has quit [Ping timeout: 240 seconds]
kroon has joined #imx6-dev
simmel80___ has quit [Remote host closed the connection]
obinou_ has quit [Quit: No Ping reply in 300 seconds.]
obinou_ has joined #imx6-dev
Esmil has joined #imx6-dev
diego_r has quit [Quit: Konversation terminated!]
rz2k has joined #imx6-dev
hste_ has quit [*.net *.split]
hste_ has joined #imx6-dev
fossxplorer has quit [Remote host closed the connection]
bfederau has quit [Remote host closed the connection]