07:42 <m1r> good morning. what battery voltage is required, 3V or 1.5V ?

08:06 <m1r> found it, thanks

16:03 <ico> hi

16:08 <ico> can i install openelec on radxa ? or xmbc distrib

19:01 <ChALkeR> To get 32 bits (instead of 16) in linux by default it is enough to: 1) Enable CONFIG_LOGO_LINUX_BMP in kernel config, 2) set correct rgba values, rk_fb sets 5/11,6/5,5/0,0/0 even for 32bit.

19:02 <ChALkeR> That gives 24bit rgb colors.

19:13 <ATP> hello ... i search more informations about 'Rockchip Linux Upgrade Tool' as documentations, files pdf ... if exists !?

19:16 <ATP> this url ( http://wiki.radxa.com/Rock/flash_the_image#Linux ) provide more little informations ;-) (thanks for naobsd)

19:17 <ChALkeR> ATP: One thing to mention: it does not require sude, a corresponding udev rule will work perfectly.

19:17 <ChALkeR> *sudo

19:17 <ChALkeR> The manual says to launch it with sudo, but that's not required.

19:19 <ATP> yes ! not problem for me ... (same error on documentation for rkflashtool ;-) ...)

19:20 <ChALkeR> echo 'SUBSYSTEMS=="usb", ATTRS{idVendor}=="2207", ATTRS{idProduct}=="310b", MODE="0666"' > /etc/udev/rules.d/90-radxa.rules; sudo udevadm control --reload-rules

19:20 <ChALkeR> Something like that.

19:20 <ChALkeR> =)

19:21 <ChALkeR> Just in case someone else reads the logs.

19:21 <ATP> log irc?

19:21 <ChALkeR> http://irclog.whitequark.org/radxa

19:22 <ATP> From 17h tonight, that's what I do ... From 07/2014 to today :p

19:24 <ATP> I found all informations i needed ... i would like to find more informations about 'Rockchip Linux Upgrade Tool' ;-)

19:25 <ATP> more explanations ;-)

19:25 <ATP> if it's possible!? :D

19:55 <ChALkeR> btw, why is the default driver built with 16 bpp?

20:55 <else-> i can't seem to get into recovery, any idea?

20:57 <else-> when i press the recovery button during power-on it does not seem to boot the stock image (no screen signal), but i don't get any new usb device

21:56 <ChALkeR> else-: The recovery button is on the left of usb, are you pressing the right one?

21:58 <ChALkeR> else-: You should disconnect power and otg before pressing the button.

22:13 <else-> ChALkeR: do i need to connect both otg and power? i've only used otg.

22:58 <else-> tried that as well now, device does not show up

23:20 <else-> okay got it, bad cable