<premoboss>
on GPIO on the right (near rj45) there are a lot of signals that has not a pin number. fro example, on PCB the pin 1 (the squared pin) is in corrisponcence with the VCC-5V. if i mesure with tester pin 1 (VCC) and ping 19 (grn) is see there is 5V, and it is ok. but on legend on the right there is that PG3 is on pin 1... but pin 1 is VCC. or maybe the legend is relative to the position of the pin on the strip? in that case, PG
<premoboss>
3 is on "logical" pin 1 that is equicvalent to "phisical" pin 8. is correct?
lkoranda has quit [Quit: Splunk> Be an IT superhero. Go home early.]
firemanxbr has joined #cubieboard
kaspter has joined #cubieboard
nils__2 has joined #cubieboard
nils_2 has quit [Ping timeout: 255 seconds]
nils__2 is now known as nils_2
nils_2 has quit [Changing host]
nils_2 has joined #cubieboard
lkoranda has joined #cubieboard
kaspter has quit [Ping timeout: 248 seconds]
imcleod has joined #cubieboard
tat has quit [Remote host closed the connection]
tat has joined #cubieboard
streptotrichosis has quit [Remote host closed the connection]
dh64 has quit [Quit: Konversation terminated!]
rangerpbzzzz is now known as rangerpb
DV has quit [Quit: Leaving]
imcleod has quit [Ping timeout: 264 seconds]
JohnDoe_71Rus has quit [Quit: Miranda IM! Smaller, Faster, Easier. http://miranda-im.org]
lauri has joined #cubieboard
<lauri>
Hi, is there a way to rotate display under Xorg with Cubietruck?
mesamoo has joined #cubieboard
imcleod has joined #cubieboard
DV has joined #cubieboard
dizzuhen has joined #cubieboard
madmaxx has joined #cubieboard
firemanxbr has quit [Read error: Connection reset by peer]
firemanxbr has joined #cubieboard
ssvb has joined #cubieboard
firemanxbr has quit [Read error: Connection reset by peer]