Stormwind_mobile has quit [Remote host closed the connection]
Stormwind_mobile has joined #glasgow
thaytan has joined #glasgow
ali_as has quit [Quit: zzzzzzzzzzzzzzzzzzzzzzzzzzzzzzZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZz]
zkms has quit [Quit: reboot]
zkms has joined #glasgow
diverger has quit [Ping timeout: 265 seconds]
diverger has joined #glasgow
<lukego>
Thanks for the tips!
pie_[bnc] is now known as pie_
pie_ is now known as pie__
pie__ is now known as pi^e
pi^e is now known as pi^e_
pi^e_ is now known as pie_[bnc]
Stormwind_mobile has quit [Remote host closed the connection]
ali_as has joined #glasgow
ali-as has joined #glasgow
ali_as has quit [Client Quit]
bvernoux has joined #glasgow
<lukego>
Just curious whitequark how did you do the vapor phase on A/B? expensive oven, cheap oven, diy?
<lukego>
JLCPCB wrote me and asked me to confirm whether I want the pads for R50, R51, D12, D13, REQ(?) open on the stencil or not. Just sharing, don't know why. I said yes because I figure it's easier to mask them out than drill them later.
<Twix>
jlcpcb ask me the same thing, too. I told them that the data is correct as these pads intentionally do not have solder paste. These parts are marked as DNP
<whitequark>
lukego: i bought a rice cooker for 100 HKD and connected it to a PID controller
AlexSalikov has joined #glasgow
AlexSalikov has quit [Remote host closed the connection]
ali-as has quit [Ping timeout: 256 seconds]
ali_as has joined #glasgow
<lukego>
Cool. and put Galden 230 into that or some other trick?
<whitequark>
yes
<whitequark>
the main thing is you should not overheat it
<whitequark>
i would suggest you have two independent safety shutoffs that won't let it run dry or too hot