BenG83 has quit [Read error: Connection reset by peer]
nasuga has joined #linux-rockchip
lurchi_ is now known as lurchi__
lurchi__ is now known as lurchi_
Substring has quit [Ping timeout: 258 seconds]
cyteen has joined #linux-rockchip
<micken>
so.. no answer
<micken>
where can I ask hw SOC related questions?
<micken>
not related to linux?
lurchi_ is now known as lurchi__
<mmind00>
micken: "No clue about CRU_SOFTRST7_CON?" is not really a question :-)
<micken>
I know
<micken>
I asked a bit more about an hour earilier
<phh>
uh, I'm not seeing anything in my logs
<micken>
I need to use CRU_SOFTRST7_CON without linux
<micken>
from linux or if I softreset into uboot , I can use it
<micken>
If I just power up I can't
<micken>
So my question is , what is needed before a write to that register?
<micken>
test case is simple: I need to reset HDMI
<micken>
write bit 25 and 9
<micken>
that gives the register value of 0x200
<micken>
in reset state
<micken>
but strait from powerup it does nothing
<micken>
ie the register is 0x0
<micken>
and no effect
<phh>
is PD_VIO up?
<micken>
I think so
<micken>
power on is "0" right?
<phh>
I guess
<phh>
the status says the same thing as the con reg?
<micken>
PD status?
<micken>
yes
<micken>
But I need to check the manual there , I was under impression last time I looked that the status reg was similar to con reg
<micken>
ok checked
<micken>
both is on=0
<phh>
I'm too lazy to check, but is that enough to clock pd_vio, or you need to do something additionally?
<micken>
hmm
<micken>
Is there clocking related to PD`?
<micken>
It looks like u-boot puts it in "normal" mode
<micken>
from CRU trm: pd_bus_ , is that somthing?
<amstan>
mmind00: did you ever try kdevelop for the kernel?
<mmind00>
amstan: nope ... I'm mostly using vim and/or kate ... and a lot of terminals :-)
<mmind00>
amstan: I tend to dislike applications, where I need to remember what buttons to click :-D
<mmind00>
micken: in general all soc components seem to start in the "on" position (power-domains, clock gates etc) ... so I cannot really imagine right now what could be off in your case ... especially as I don't think there is anything getting turned on regarding soft-resets in uboot or the linux kernel
<micken>
mmind00: ok
<micken>
mmind00: thats what I thought
<micken>
mmind00: I am trying to bringup HDMI in RISC OS
<micken>
which is a opensource project
<micken>
But it isn't GPL and it is written in assembler
ganbold has quit [Ping timeout: 240 seconds]
<micken>
I whish there was application notes for all this
nighty-- has quit [Quit: Disappears in a puff of smoke]