<adamw_> roh, we have another passed ethernet connector while producing m1 rc1 http://downloads.qi-hardware.com/hardware/milkymist_one/datasheet/Ethernet/RTF-114B8A1A(023-00).pdf
<adamw_> when you have time, would you please check if its outlet dimension is still matched your case design?
<adamw_> i was thought and compared both two connectors, so hope the tolerance from your design can meet it.
<roh> i have tested it with an rc2 and rc1 and both fit
<adamw_> the 'RTF-114B8A1A' part with 'UDE' brand mark on connector itself. Not sure your rc1 is the 'UDE' part.
<adamw_> So please check if it's not. tks!
<wolfspraul> adamw_: on rc3, we should make the dc-10 jack tighter/less tolerance
<adamw_> while producing 6pcs in rc1, i have three ethernet connector with 'UDE' part, the other three with Molex http://www.molex.com/pdm_docs/sd/480250002_sd.pdf
<adamw_> wolfspraul, yes, i put them into our known issue items, http://en.qi-hardware.com/wiki/Milkymist_One_RC2_Known_Issues
<wolfspraul> great, thx
<adamw_> so while routing, surely I'll check that DC jack. :)
<mumptai> moin
<larsc> moin moin :)
<mumptai> dahh, ein hamburger ;)
<larsc> jup
<mumptai> sits in bremen
<larsc> ah, nice. do you have a milkymist board?
<mumptai> nope
<mumptai> i have a unused nexys2, but i doubt that i could port milkymist to it
<roh> bit too small i guess (s3e)
<mumptai> roh, and a small memory i/f
<kristianpaul> mumptai: you can
<kristianpaul> or try
<kristianpaul> check the avnet port in github
<kristianpaul> or just syhtetize with lm32 + gpio + uart + sram (check old commits or avport)
<mumptai> the minimal soc should work, but the image-processing pipeline might not fit
<kristianpaul> oh, sure will not ;-)
<mumptai> and if it fits in the fpga, the sram via the async i/f might be a bit too slow (16bit, about 75ns)
<kristianpaul> (BYU RapidSmith Project) how do you find ths project?
<kristianpaul> ah, lekernel, i hope you read logs :-)