16:40 <vorian456> I am attempting to boot the sopine/baseboard using sunxi-fel, currently u-boot is built using a buildroot defconfig very similar to the default. According to the wiki I need a u-boot image that includes SPL, buildroot is generating sunxi-spl.bin, and u-boot.bin separately. Does anybody have a suggestion on how to get them into a single image? Thank

16:40 <vorian456> you.

16:42 <vorian456> I should have stated above. I am able to communicate with the a64 from sunxi-fel, and I have attempted to load both sunxi-spl.bin and u-boot.bin using sunxi-fel spe/uboot commands. Currently booting sunxi-spl.bin always gives the error "SPL: Unsupported Boot Device!".

16:57 <jernej> booting 64-bit devices through FEL is not supported out of the box

16:57 <jernej> but you can hack it around a bit

16:58 <jernej> by compiling SPL in 32-bit mode and loading each part separately

17:08 <vorian456> Is there instructions that outline that process written down somewhere? I didn't see that in the wiki. I am also curious if anybody has had any luck using the USB ethernet gadget on the a64? I was not sure if I had configured u-boot incorrectly or if the software that supports it doesn't exist.

17:09 <vorian456> I was not able to get u-boot to build with it enabled, due to some undefined references. Making me think the software required just doesn't exist.

17:10 <jernej> nope, there are no instructions for that and you have to hack U-Boot source

17:11 <jernej> at least I don't know for any instructions

17:13 <jernej> well, check logs for this channel, it was discussed in the past

19:54 <mps> kernel 5.8.5 and up cannot boot if it is built with thumb2, binutils 2.34 and up and gcc 10.2.0

19:56 <mps> at least on A20 banana pi old board

20:50 <rz> can someone please provide a link to T2 (renewed A20) datasheet ?

20:50 <rz> googling does not give anything