OneManHateGroup has quit [Remote host closed the connection]
tllim has joined #linux-sunxi
tllim has quit [Client Quit]
lurchi__ is now known as lurchi_
<Kamilion>
karlp: lot of the USB to UART adapters have a GPIO mode (like the FTDI FT2232HL) and the drivers for them can allow for high speed serial links using alternative transports. SPI, I2C, JTAG, esoteric serial protocols like the commodore 64 and Atari's SIO bus, RS-485 multidrop, others.
popolon has quit [Quit: WeeChat 2.3]
<Kamilion>
dude probably just needed a pomona soic-clip.
<Kamilion>
if onemanhategroup comes back, point 'em at the libreboot procedures for reflashing one of the thinkpads. There's a ton of them out there and good pictures to go with it.
leviathan has quit [Remote host closed the connection]
itdnhr has joined #linux-sunxi
itdnhr has quit [Ping timeout: 252 seconds]
itdnhr has joined #linux-sunxi
m4ssi has joined #linux-sunxi
itdnhr has quit [Ping timeout: 268 seconds]
itdnhr has joined #linux-sunxi
\\Mr_C\\ has quit [Quit: (Read error: Connection reset by beer)]
alexxy has quit [Read error: Connection reset by peer]
itdnhr has quit [Ping timeout: 246 seconds]
itdnhr has joined #linux-sunxi
msimpson has joined #linux-sunxi
pgreco has quit [Ping timeout: 264 seconds]
pgreco has joined #linux-sunxi
itdnhr has quit [Ping timeout: 268 seconds]
itdnhr has joined #linux-sunxi
kuhn[m] has quit [Write error: Connection reset by peer]
k40s[m] has quit [Write error: Connection reset by peer]
z3ntu1 has quit [Remote host closed the connection]
ildar has quit [Read error: Connection reset by peer]
zongzor has quit [Remote host closed the connection]
YannSoubeyrand[m has quit [Remote host closed the connection]
MartijnBraam has quit [Read error: Connection reset by peer]
GuLinux[m] has quit [Remote host closed the connection]
oliver[m] has quit [Remote host closed the connection]
mic-e[m] has quit [Write error: Connection reset by peer]
t4h4[m] has quit [Write error: Connection reset by peer]
romainmahoux[m] has quit [Write error: Connection reset by peer]
masterdonx has quit [K-Lined]
itdnhr has quit [Ping timeout: 240 seconds]
Gerwin_J has joined #linux-sunxi
k40s[m] has joined #linux-sunxi
pgreco has quit [Ping timeout: 250 seconds]
pgreco has joined #linux-sunxi
Pe3ucTop has quit [Ping timeout: 250 seconds]
mic-e[m] has joined #linux-sunxi
GuLinux[m] has joined #linux-sunxi
t4h4[m] has joined #linux-sunxi
romainmahoux[m] has joined #linux-sunxi
kuhn[m] has joined #linux-sunxi
ildar has joined #linux-sunxi
MartijnBraam has joined #linux-sunxi
oliver[m] has joined #linux-sunxi
z3ntu has joined #linux-sunxi
zongzor has joined #linux-sunxi
YannSoubeyrand[m has joined #linux-sunxi
The_Loko has joined #linux-sunxi
itdnhr has joined #linux-sunxi
Gerwin_J has quit [Quit: Gerwin_J]
itdnhr has quit [Ping timeout: 252 seconds]
itdnhr has joined #linux-sunxi
BenG83_ has quit [Ping timeout: 240 seconds]
itdnhr has quit [Ping timeout: 252 seconds]
itdnhr has joined #linux-sunxi
jbrown has quit [Ping timeout: 264 seconds]
<karlp>
Kamilion: that's true, but it's still not remotely valid to say that UART and jtag is the same, just because some usb-uart ICS have alternate modes that let them wiggle pins
netlynx has joined #linux-sunxi
netlynx has joined #linux-sunxi
netlynx has quit [Changing host]
jbrown has joined #linux-sunxi
itdnhr has quit [Remote host closed the connection]
itdnhr has joined #linux-sunxi
itdnhr has quit [Read error: Connection reset by peer]
itdnhr_ has joined #linux-sunxi
itdnhr_ has quit [Ping timeout: 252 seconds]
itdnhr has joined #linux-sunxi
clemens3 has quit [Ping timeout: 240 seconds]
itdnhr has quit [Ping timeout: 268 seconds]
itdnhr has joined #linux-sunxi
hitech95_ROG has joined #linux-sunxi
leviathan has joined #linux-sunxi
itdnhr has quit [Ping timeout: 240 seconds]
<MoeIcenowy>
Kamilion: what's the JTAG compatibility of blackmagic?
<plaes>
MoeIcenowy: I tried it a while ago, but I couldn't get it working properly :(
<plaes>
but I could lack some skills :)
<MoeIcenowy>
I now use a STM32F103CB based STLinkV2 clone dongle flashed with USB Blaster emulation
<MoeIcenowy>
I used it for hacking into the secure world of H3 ;-)
<MoeIcenowy>
(or saying precisely, used it to dump the Secure BROM of H3
<plaes>
nice
<MoeIcenowy>
it's what I have done several months ago ;-)
<plaes>
yeah, I used the ft232h for one atmel sam4 project
<plaes>
just needed to reflash bunch of devices
<MoeIcenowy>
one advantage of such a dongle is that it can be purchased for CNY ￥10 at Chinese
<MoeIcenowy>
I have another one that runs STLinkv2 clone firmware, which is used to flash other STM32's, and found that it even convenient than a genius STLink ;-)
<plaes>
heh
<MoeIcenowy>
as my boards usually lacks the 20pin connector
<koty0f>
is there some way to force hdmi connector to be connected at boot on A64? Now I'm using echo on > /sys/class/drm/card0-HDMI-A-1/status from userspace
AneoX has quit [Ping timeout: 252 seconds]
itdnhr has quit [Ping timeout: 268 seconds]
jbrown has joined #linux-sunxi
msimpson has joined #linux-sunxi
lurchi__ has joined #linux-sunxi
<plaes>
something like: video=HDMI-A-1:D
mavkhimenia has joined #linux-sunxi
mavkhimenia has quit [Read error: No route to host]
mavkhimenia has joined #linux-sunxi
mavkhimenia has quit [Remote host closed the connection]
mavkhimenia has joined #linux-sunxi
lurchi__ has quit [Ping timeout: 252 seconds]
mavkhimenia has quit [Remote host closed the connection]
lurchi__ has joined #linux-sunxi
itdnhr has joined #linux-sunxi
f11f13 has quit [Quit: Leaving]
mavkhime_ has joined #linux-sunxi
mavkhime_ has quit [Ping timeout: 268 seconds]
<koty0f>
plaes: thx. Even thow this forces connection correctly, it seems no HDMI signal is going out.
itdnhr has quit [Ping timeout: 244 seconds]
itdnhr has joined #linux-sunxi
f0xx has quit [Ping timeout: 252 seconds]
lstanley0 has joined #linux-sunxi
lstanley0 has quit [Remote host closed the connection]
itdnhr has quit [Ping timeout: 245 seconds]
<plaes>
which device?
<plaes>
and which display?
<plaes>
and can you dump the edid?
<plaes>
I have seen similar issue with certain displays
itdnhr has joined #linux-sunxi
itdnhr has quit [Remote host closed the connection]
itdnhr has joined #linux-sunxi
JohnDoe_71Rus has joined #linux-sunxi
<koty0f>
My setup is A64 HDMI->TC358870->DSI display panel
<koty0f>
When I load manualy from userspace my module for TC358870 and execute echo on > /sys/class/drm/card0-HDMI-A-1/status everything is working. The LCD initiates and displays console
<koty0f>
But if I force HDMI-A from cmdline, TC358870 module returnes with error that there is no HDMI signal (module waits in while loop checking some registers of the brigde)
reinforce has joined #linux-sunxi
Andy-D has quit [Ping timeout: 272 seconds]
Andy-D has joined #linux-sunxi
itdnhr has joined #linux-sunxi
wigyori has joined #linux-sunxi
wigyori has quit [Changing host]
wigyori has joined #linux-sunxi
Gerwin_J has joined #linux-sunxi
yann has joined #linux-sunxi
itdnhr has quit [Ping timeout: 268 seconds]
mavkhimenia has joined #linux-sunxi
mavkhimenia has quit [Remote host closed the connection]
itdnhr has joined #linux-sunxi
mavkhimenia has joined #linux-sunxi
mavkhime_ has joined #linux-sunxi
mavkhim__ has joined #linux-sunxi
mavkhime_ has quit [Read error: Connection reset by peer]
matthias_bgg has quit [Ping timeout: 268 seconds]
mavkhimenia has quit [Ping timeout: 260 seconds]
mavkhim__ has quit [Remote host closed the connection]
megi has joined #linux-sunxi
mavkhimenia has joined #linux-sunxi
anarsoul|2 has joined #linux-sunxi
koty0f has quit [Ping timeout: 268 seconds]
leviathan has quit [Remote host closed the connection]
Pe3ucTop has joined #linux-sunxi
Pe3ucTop has quit [Client Quit]
mavkhimenia has quit []
m4ssi has quit [Remote host closed the connection]
Gerwin_J has quit [Ping timeout: 264 seconds]
jbrown has quit [Ping timeout: 268 seconds]
Gerwin_J has joined #linux-sunxi
masterdonx has joined #linux-sunxi
masterdonx has quit [K-Lined]
vagrantc has joined #linux-sunxi
koty0f has joined #linux-sunxi
popolon has joined #linux-sunxi
tnovotny has quit [Quit: Leaving]
hitech95_ROG has quit [Ping timeout: 245 seconds]
reinforce has quit [Quit: Leaving.]
chrisf_ has quit [Quit: Ex-Chat]
reinforce has joined #linux-sunxi
chrisf_ has joined #linux-sunxi
<BenG83>
MoeIcenowy, do you know which sensor is in CUBE?
msimpson has quit [Quit: Leaving]
clemens3 has quit [Ping timeout: 252 seconds]
yann has quit [Ping timeout: 268 seconds]
<BenG83>
is it GC2035?
<anarsoul|2>
BenG83: she's probably sleeping
Gerwin_J has quit [Quit: Gerwin_J]
<BenG83>
is anyone going to CCC this year?
Gerwin_J has joined #linux-sunxi
Gerwin_J has quit [Client Quit]
Gerwin_J has joined #linux-sunxi
Gerwin_J has quit [Client Quit]
t0dd1v has joined #linux-sunxi
lynxis has quit [Remote host closed the connection]
lynxis has joined #linux-sunxi
koty0f has quit [Quit: Leaving]
formruga has quit [Quit: Konversation terminated!]
AneoX_ has quit [Read error: Connection reset by peer]
AneoX has joined #linux-sunxi
tl_lim has joined #linux-sunxi
tllim has joined #linux-sunxi
victhor has joined #linux-sunxi
t0dd1v has quit [Quit: Connection closed for inactivity]
The_Loko has quit [Remote host closed the connection]
tl_lim has quit [Quit: Leaving]
bimawa has joined #linux-sunxi
bimawa has quit [Remote host closed the connection]
Ntemis has joined #linux-sunxi
reinforce has quit [Quit: Leaving.]
lurchi_ has joined #linux-sunxi
lurchi__ has quit [Ping timeout: 268 seconds]
matthias_bgg has joined #linux-sunxi
MaxwellSmart has joined #linux-sunxi
matthias_bgg has quit [Ping timeout: 244 seconds]
<MoeIcenowy>
BenG83: I don't know
<anarsoul|2>
morning, MoeIcenowy
<anarsoul|2>
MoeIcenowy: did you try to get rtl8723cs bluetooth working on mainline kernel?
<anarsoul|2>
it works for me on rtl8723bs on pine64 with wifi+bt module, but doesn't on rtl8723cs on pinebook :(
<MoeIcenowy>
never tried BT
<anarsoul|2>
I see
tllim has quit [Remote host closed the connection]
tllim has joined #linux-sunxi
matthias_bgg has joined #linux-sunxi
Mr__Anderson has quit [Remote host closed the connection]
afaerber has quit [Quit: Leaving]
tllim has quit [Read error: Connection reset by peer]
Putti has quit [Ping timeout: 264 seconds]
afaerber has joined #linux-sunxi
matthias_bgg has quit [Ping timeout: 240 seconds]
fdcx has quit [Ping timeout: 246 seconds]
<Kamilion>
oh, nice, and it support bluepill and blackpill boards. <3
<Kamilion>
ack, window didn't scroll.
<Kamilion>
MoeIcenowy: JTAG works fairly well on the blackmagic but it's *slow*. the FT2232 is a lot faster. If you're got a real segger jlink, those are generally the fastest I've used so far.
<Kamilion>
blackmagic probe is definitely not well suited to fast ARMs; but works more or less fine on the 'slow' M0s
<Kamilion>
I've got a growing pile of H6s that I'd like to get mainline on; which is why I've been lurking here watching.
<Kamilion>
Orange Pi Lite 2 boards; been thinking of grabbing one of the pine boards too, since I've seen more traffic around supporting it.
<Kamilion>
two majors I need is SPI for 'flashrom' and UASP.ko working for either the USB2 or USB3 so I can play with 'smartctl' and friends.
Ntemis has quit [Read error: Connection reset by peer]
<Kamilion>
kinda bummed the usb3 support is a low priority for mainline