ChanServ changed the topic of ##yamahasynths to: Channel dedicated to questions and discussion of Yamaha FM Synthesizer internals and corresponding REing. Discussion of synthesis methods similar to the Yamaha line of chips, Sound Blasters + clones, PCM chips like RF5C68, and CD theory of operation are also on-topic. Channel logs: https://freenode.irclog.whitequark.org/~h~yamahasynths
Xyz39808 has joined ##yamahasynths
Xyz_39809 has quit [Ping timeout: 260 seconds]
Xyz_39809 has joined ##yamahasynths
Xyz39808 has quit [Ping timeout: 260 seconds]
Xyz39808 has joined ##yamahasynths
Xyz_39809 has quit [Ping timeout: 260 seconds]
brezza_dsa has joined ##yamahasynths
_whitelogger has joined ##yamahasynths
brezza_dsa has quit [Quit: Leaving...]
<cr1901_modern> whitequark: You may have muted the thread by now, but in the interest of being correct and updating my priors: It looks like I (and Wikipedia, pinouts.ru) are wrong: https://twitter.com/cr1901/status/1218816972336615425
<cr1901_modern> historically* correct
<whitequark> yea
nukeykt has joined ##yamahasynths
grauw has joined ##yamahasynths
Patater_ is now known as Patater
cr1901_modern has quit [Quit: Leaving.]
cr1901_modern has joined ##yamahasynths
<whitequark> this is now permanently on
<cr1901_modern> Awesome!
<whitequark> it's connected to the absolute sketchiest setup with my rpi
<whitequark> the rpi is hanging (like, literally) from the USB cable that's wrapped around a light fixture
<whitequark> for ... reasons
<cr1901_modern> I'm guessing even USB-compliant cables are not tested for the maximum load they can tolerate in rope configuration
<whitequark> hmmm, let me check the spec
<whitequark> cr1901_modern: there is
<whitequark> 40 newtons axial load
<cr1901_modern> oh good God lmfao
<whitequark> that's uh, 4 kgf
<cr1901_modern> Well, a Pi should be quite safe then
<whitequark> not quite
<whitequark> the Pi is not symmetric in terms of weight
<whitequark> so this isn't an axial load
<whitequark> there *is* a spec for non-axial loads too, though
<whitequark> ok, so non-axial loads with moment of up to 0.75 Nm should not unmate the connector
<whitequark> that's still ok for the pi
<cr1901_modern> Also, I forgot to divide by 10 when converting to kilos
<cr1901_modern> (Unless I don't have to)
<whitequark> I use rink
<whitequark> I hate thinking and memorizing
<whitequark> the computer ought to do both
<cr1901_modern> Oh right, I need to reinstall that
cr1901_modern1 has joined ##yamahasynths
cr1901_modern has quit [Ping timeout: 272 seconds]
cr1901_modern1 has quit [Quit: Leaving.]
cr1901_modern has joined ##yamahasynths
l_oliveira has joined ##yamahasynths
ZirconiumY has joined ##yamahasynths
ZirconiumX has quit [Ping timeout: 252 seconds]
ZirconiumY is now known as ZirconiumX
nukeykt has quit [Remote host closed the connection]
grauw has quit []